We choose not to show debug messagesįoreach (AnalogChannel ch in AnalogChannel. 6:08:29 PM INFO Device connected of type SmartScope with serial 00513005A14Ĭhannel A - Vertical range : Ĭhannel B - Vertical range : ġ12įirst off, we use the to easily output information to the console and see where things go wrong in LabNation.DeviceInterface which also uses this Logger. The app shows the average voltage measured on each channel like below: 6:08:26 PM INFO LabNation SmartScope Console Demo You can change that though in the project options of SmartScopeConsole Run > General > Run on external console ZONE3® 3D CAD -based metrology software makes every Flash model a powerful video measuring system. MonoDevelop doesn't seem to run the app in an external console by default which leads to poor console support. SmartScope Flash can be configured as an economical yet capable multisensor metrology system, with numerous combinations of touch probes, scanning probes, micro-probes, and lasers. They are configured in DC coupling for a x10 probe and a 0V vertical offset. Our Signature Product The Tejco Follicular Smartscope Prime Is A Must Have For Every Clinic Practice. timeout when no trigger) with an input range of -3V to 3V on both channels. Insert the software installation CD into the CD-ROM drive. #SMARTSCOPE SETUP INSTALL#The software will install automatically.(fig.1) 1. c.) Place the microscope on the stand holder. When running the app, the smartscope is configured to make 20us acquisitions in AUTO trigger mode (i.e. Press the holder, pull up and down to adjust the distance between the microscope and the object. Then open the generated SmartScopeConsole.sln file with Xamarin/MonoDevelop/VisualStudio. To get started, check out the repository. A simple console demo of the LabNation SmartScope Device Interface API.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |